 | |  |
|
 A brake wherein the friction is supplied by a set of brake shoes or brake pads that press against a rotating drum unit called a brake drum. There are a few particular differences among brake drum kinds. A "brake drum" is commonly the definition provided if shoes press on the inner surface of the drum. A "clasp brake" is the term utilized in order to describe whenever shoes press next to the outside of the drum. Another kind of brake, called a "band brake" makes use of a flexible band or belt to wrap round the exterior of the drum. If the drum is pinched in between two shoes, it can be called a "pinch brake drum." Like a standard disc brake, these types of brakes are quite uncommon.
Early brake drums, before nineteen ninety five, required to be consistently adjusted so as to compensate for wear of the drum and shoe. "Low pedal" can result if the needed adjustments are not carried out satisfactorily. The vehicle could become hazardous and the brakes can become ineffective if low pedal is mixed along with brake fade.
There are different Self Adjusting Brake Systems accessible, and they could be categorized within two main types, RAD and RAI. RAI systems have built-in tools that prevent the systems to be able to recover whenever the brake is overheating. The most recognized RAI makers are Lucas, Bosch, AP and Bendix. The most famous RAD systems consist of Volkswagen, VAG, AP, Bendix and Ford recovery systems.
Self repositioning brakes generally use a tool that engages just whenever the motor vehicle is being stopped from reverse motion. This stopping approach is acceptable for use where all wheels make use of brake drums. Most vehicles nowadays make use of disc brakes on the front wheels. By operating only in reverse it is less probable that the brakes would be adjusted while hot and the brake drums are expanded. If adjusted while hot, "dragging brakes" can happen, which raises fuel expenditure and accelerates wear. A ratchet mechanism which becomes engaged as the hand brake is set is one more way the self adjusting brakes may function. This means is just suitable in applications where rear brake drums are utilized. Whenever the parking or emergency brake actuator lever goes over a specific amount of travel, the ratchet improvements an adjuster screw and the brake shoes move toward the drum.
There is a manual adjustment knob located at the bottom of the drum. It is usually adjusted through a hole on the opposite side of the wheel and this requires going underneath the forklift using a flathead screwdriver. It is of utmost importance to move the click wheel correctly and adjust every wheel evenly. If unequal adjustment takes place, the vehicle can pull to one side during heavy braking. The most efficient method so as to make sure this tiresome job is accomplished safely is to either raise each and every wheel off the ground and hand spin it while measuring how much force it takes and feeling if the shoes are dragging, or give everyeach and every one the exact amount of clicks utilizing the hand and then perform a road test.
| |
 | |  |
